Threaded View
-
12-03-2018 #9
Found a little time to continue with this. The main box is pretty much done. Admittedly, it's all a bit tatty and meccano..ish, but it'll do for the shed wall. All powers up fine, just need to tidy the wiring before I wire the D-Sub for the limit switches.
Still need to make the box for the DDCS. The DDCS powers up, but have to wire the MPG/switches. estop, pump-switch and possibly one or two other things. Going to try wiring up first to see if it all works.
Dang! Where do I start :(
Might need some help wiring the 5 position rotary switches for X,Y,Z and 1x, 10x, 100x on the MPG control.Last edited by Rye; 12-03-2018 at 04:09 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
5 axis BoB spindle control help needed
By Noddy in forum General DiscussionReplies: 18Last Post: 07-03-2018, 09:58 PM -
Control box
By Kev2960 in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 03-02-2017, 11:14 PM -
Exractor control
By gorbo in forum Workshop & EquipmentReplies: 5Last Post: 24-12-2015, 03:06 PM -
Advice Needed - Control Panel
By GTJim in forum General ElectronicsReplies: 0Last Post: 18-04-2013, 08:23 AM -
servo control vs stepper control
By Peter. in forum Motor Drivers & ControllersReplies: 24Last Post: 17-09-2012, 08:36 AM
Bookmarks