UC CNC software 300eth and UB1

[Neale]

I'm currently using a CSMIO-IP/M. The UC300ETH/UB1 combination is very similar with a few improvements from a hardware point of view, and I would be looking at the newer hardware if I were starting again now. As far as BOB functionality is concerned, things like differential motion signals, 24V signalling, isolated VFD analogue output, are all highly desirable. I like the idea of spring terminals as well - more reliable long-term than screw terminals. These are all relatively high-end BOB features and you don't find them in the bargain box on eBay. I have to say that my first router used a cheap BOB with 5V all round and didn't give any problems - but then, I wasn't using speed control or had any limit switches either!

[Ger21]

1) I think that I'm the only one that offers a UCCNC screenset. It basically just adds probing, and auto zero macros.
As UCCNC is constantly adding new features, my screenset may not support all UCCNC features until I have a chance to update it.

3) The UB1 is not programmable. What you are referring to is the UC300ETH firmware. UCCNC actually loads different screens depending on the motion controller connected. As of about 10 version ago, UCCNC can detect the UB1, and load screens made for it.

4) 24V I/O, differential step/dir, analog inputs, charge pump output, speed control, relays.

5) Any available inputs, I believe.