hey lads, ive not been on 4 a while due to changin my ideas on a few things for my 1st build an am now seekin advise on these, im still lookin at doin 3d carvings

1, has any1 any thoughts on the "bearing an ally angle method" for the slides as shown on buildyourcnc.com???

2, has any1 any thoughts on the 3axis stepper motor complete kit for 128 quid on ebay???

3, would a stripped down plunge router work as a spindle or would there be too much "slop"???

4, is tr10x2d with delrin nuts sufficient as lead screws???

im still not sure wether to use a fixed gantry or not coz i wont need a table bigger than 400mm x400mm but its always nice to have a few extra inches eh:naughty: