Quote Originally Posted by johnsattuk View Post
Il'l try this on a bit of sycamore I have, might even use a bit of zabrani I have been saving for years.

Can you give a clue to the cutter you used
Sure - I used a 4mm square end mill for the roughing and a 4mm ball nose for the finishing. In all honesty a 3mm would be better for the finishing pass, but you'd need a long neck/flute or a shaft no thicker than 3mm to avoid rubbing on the steep sides... I may flare out the troughs and the front and rear faces a bit on the newer model to make it a bit easier to cut...

Wal.

Sent from my HTC One M9 using Tapatalk