. .
Page 2 of 3 FirstFirst 123 LastLast
  1. #11
    Nice one
    Was looking at the j tech 4w laser engraver.. but man what a price for a 4w laser.

  2. #12
    Quote Originally Posted by jmac80 View Post
    Oh man that look's sweeet
    Dean makes some nice parts I've seen them in the flesh.

  3. The Following User Says Thank You to JAZZCNC For This Useful Post:


  4. #13
    Dean makes some nice routers I’ve got one

  5. #14
    me also one day :)
    jazzcnc any ideas on mounting a drag bit to the Z, easy enough to add later or best to incorporate into design now?
    Last edited by jmac80; 03-04-2018 at 06:23 PM.

  6. #15
    Quote Originally Posted by jmac80 View Post
    me also one day :)
    jazzcnc any ideas on mounting a dragknife to the Z, easy enough to add later or best to incorporate into design now?
    Best done now really but to be fair if your only using occasionally then I wouldn't worry about using it in the spindle.

  7. #16
    ok cheers mate

  8. #17
    At the risk of seeming a pit picky can I point out that Drag Engraving Cutters are a different thing to Drag Knives, one is not directional and is used for engraving hard surfaces, the other is directional, cutting sheet material and swivels under drag or power to maintain orientation in the direction of cut.
    Anyone searching for Drag Knives may be confused.
    You think that's too expensive? You're not a Model Engineer are you? :D

  9. The Following User Says Thank You to magicniner For This Useful Post:


  10. #18
    Quote Originally Posted by magicniner View Post
    Anyone searching for Drag Knives may be confused.
    And so they bloody should be if reading this thread because nobody mentioned Drag knives here.!!

  11. #19
    They changed my meds, what can I say?
    You think that's too expensive? You're not a Model Engineer are you? :D

  12. #20
    I think the opening post mentioned a drag knife but you can’t etch glass and stone with these, so anybody reading the full thread won’t be confused

    It’s now been edited

Page 2 of 3 FirstFirst 123 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Drag Knife anyone?
    By JoeHarris in forum Tool & Tooling Technology
    Replies: 22
    Last Post: 07-11-2019, 08:32 PM
  2. diamond impregnated brazing rods uk
    By Fivetide in forum Welding, Brazing & Equipment
    Replies: 12
    Last Post: 23-11-2016, 11:14 PM
  3. Is there a specific setting for using a diamond drag tool for engraving?
    By petesos in forum Tool & Tooling Technology
    Replies: 4
    Last Post: 14-03-2014, 12:22 AM
  4. Drag Chains
    By Mad Professor in forum General Electronics
    Replies: 3
    Last Post: 30-04-2013, 11:23 PM
  5. Drag chains
    By jcb121 in forum General Discussion
    Replies: 4
    Last Post: 14-05-2012, 11:44 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •