Diamond drag bits

[JAZZCNC]

me also one day :)
jazzcnc any ideas on mounting a dragknife to the Z, easy enough to add later or best to incorporate into design now?

Best done now really but to be fair if your only using occasionally then I wouldn't worry about using it in the spindle.

[jmac80]

ok cheers mate

[magicniner]

At the risk of seeming a pit picky can I point out that Drag Engraving Cutters are a different thing to Drag Knives, one is not directional and is used for engraving hard surfaces, the other is directional, cutting sheet material and swivels under drag or power to maintain orientation in the direction of cut.
Anyone searching for Drag Knives may be confused.

[JAZZCNC]

Anyone searching for Drag Knives may be confused.

And so they bloody should be if reading this thread because nobody mentioned Drag knives here.!!

[magicniner]

They changed my meds, what can I say?