. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-04-2018 #9
    Doddy's Avatar
    Lives in Preston, United Kingdom.
    Doddy
    Last Activity: 25-09-2025 Has been a member for 9-10 years. Has a total post count of 1,364. Received thanks 188 times, giving thanks to others 66 times. Referred 1 members to the community.
    The point of that was to address an earlier comment that Ethernet provides error correction - which is certainly not a part of the lower comm layers. In fact, TCP/IP doesn't provide error correction - merely a retry mechanism.

    TCP/IP isn't the be-all/end-all. For the last few years I've been involved in an engineering activity centred around UDP.

    :D
    Last edited by Doddy; 05-04-2018 at 08:16 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Pci or Ethernet motion control?
    By Ross77 in forum Machine Control Software
    Replies: 27
    Last Post: 16-10-2019, 08:27 PM
  2. Any USB/Ethernet controller suggestions?
    By jtar40 in forum Motor Drivers & Controllers
    Replies: 64
    Last Post: 15-05-2019, 07:58 PM
  3. WANTED: Ethernet Smooth Stepper
    By davidimurray in forum Items Wanted
    Replies: 3
    Last Post: 08-10-2017, 02:29 PM
  4. UC300 Ethernet
    By noyloj in forum CNCdrive (UC100, UC300ETH)
    Replies: 12
    Last Post: 02-01-2017, 10:21 PM
  5. Help mach3 ethernet set up
    By kell in forum Artsoft Mach (3 & 4)
    Replies: 3
    Last Post: 06-12-2015, 10:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules