Tb6600?

[driftspin]

For anyone who has, had or knows anything about it, is there any specific break out board I should be getting with this uc300eth? I don't know much about them, I think they're generally the same but I'm not sure. How does it work with the software, interface and Bob? Are you able to set up individual pins on uccnc? Or do you need a specific break out board that is set up for the uccnc software outputs?

Sent from my Nexus 4 using Tapatalk

Hi Jtar40,

the uc300eth is mach compatible and uccnc software key is available for a lot less.
Also checkout the bob UB1 from cncroom.com

Grtz Bert.



Verstuurd vanaf mijn SM-A320FL met Tapatalk

[picclock]

Have you looked into stand alone controller like the DDCSV. Current price is similar to uc300eth, but it includes the computer part. So you upload the gcode to a usb stick, plug it in and it runs. Also works with a pendant.
Might save a lot of interface pain :-)
Best Regards
picclock