Tb6600?

[A_Camera]

For anyone who has, had or knows anything about it, is there any specific break out board I should be getting with this uc300eth? I don't know much about them, I think they're generally the same but I'm not sure. How does it work with the software, interface and Bob? Are you able to set up individual pins on uccnc? Or do you need a specific break out board that is set up for the uccnc software outputs?

You can use any BOB with the UC300ETH. Personally I have two of these:

https://www.ebay.com/itm/Geekcreit-5...item4b40cb55d4

There is no need to buy a 180$ BOB unless you know you'll need it, when you can get it working just as well with a $5 BOB. I know that just like in the case of digital vs. the 542 drivers some people will disagree, but so be it. As a student, you will be ruined if you follow some peoples advice, so be careful when asking on a forum.

Of course, if you plan on building and industrial machine then buy only the best, but if you have a hobby and/or if you have some budget restrictions then the cheaper alternatives are not necessarily worse than the $180 UB1.