-
22-04-2018 #1
I really must stop drinking before going on eBay !
Just picked up this lot - wasn't quite prepared for the size and weight of it - 1.25" shaft and two pillow blocks per shaft - 38 foot in total (as we're imperial on these units !)
A bit bigger than I wanted for my next build but possibly could accommodate a bigger machine in the new shed we're planning on building this year rather than my existing workshop.
Picked up 4 x 48" and 4 x 66" with 8 bearings / blocks for not a huge amount of money. Shafts have some minor surface rust on but should clean up ok.
Too big for a home build or about right ? Tempted to sell on and go smaller but the engineer in me says to make it as big as I can !
-
22-04-2018 #2http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm
If you didn't buy it from China the company you bought it from did ;)
-
The Following User Says Thank You to Desertboy For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
why would they sell a 2A lamp switch?
By Wal in forum General ElectronicsReplies: 13Last Post: 20-05-2017, 06:41 AM -
BUILD LOG: CNC DIY milling machine . I am considering sell it.
By adrpak in forum DIY Router Build LogsReplies: 1Last Post: 19-06-2016, 06:47 PM -
FOR SALE: SFU1605 Ballscrews and Nuts 950mm, 1150mm and 1500mm, SBR16 950 Rail, SBR20 1150 Rail
By Maccydu in forum Items For SaleReplies: 1Last Post: 12-12-2015, 09:55 PM
Bookmarks