. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Well that is very confusing! Is it a variable frequency generator to drive a stepper motor (it says that a separate drive is needed) or a PWM controller? There's a meaty device with a heatsink but maybe that's just a regulator as it says that you can supply from 160 V.

  2. #2
    Quote Originally Posted by JohnHaine View Post
    Well that is very confusing! Is it a variable frequency generator to drive a stepper motor (it says that a separate drive is needed) or a PWM controller? There's a meaty device with a heatsink but maybe that's just a regulator as it says that you can supply from 160 V.
    Either, it depends on the jumper setting.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 3
    Last Post: 02-09-2021, 11:08 PM
  2. pulse generator for M542 to use on a optimum BF46 Vario
    By gnalbant in forum Optimum Milling Machines
    Replies: 2
    Last Post: 03-07-2016, 11:50 AM
  3. Stepper motor Pulse Signal Generator module
    By Tom J in forum Motor Drivers & Controllers
    Replies: 8
    Last Post: 12-01-2016, 11:47 AM
  4. Stepper motor as a generator??
    By wiatroda in forum General Discussion
    Replies: 10
    Last Post: 08-08-2011, 10:17 PM
  5. Motor controller next to break out board?
    By m_c in forum General Electronics
    Replies: 2
    Last Post: 17-11-2010, 01:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •