Hybrid View
-
29-04-2018 #1
Does the mill have the Denford USB controller?
If it does, I would personally run with Denford's VR milling, as although pretty basic, it does work very well.
Even if you do upgrade, my preference would be individual stepper drivers.
Spindle wise to get 20-30K, you'd really need to remove the existing spindle, and look at fitting a water cooled Chinese spindle and VFD setup. It would most likely involve having to machine out the head casting to accommodate the spindle, unless you bolt it on the side.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
30-04-2018 #2
Hello M_C, yes it's a complete machine, but without the operating key or software or dongle, which have been lost by the school who owned it. They are currently refitting their entire workshop.
If you could recommend a replacement spindle I would be grateful. I'm not familiar with mills or CNC at all.
I'll also have to fit some sort of cooling device for the cutting tool too, so any help there would be appreciated. Ideally I don't want to install a liquid cooler as that will limit the places I could put it, so I'm hoping an air cooled system could be installed?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Tiny round over for edging
By Fivetide in forum Woodwork DiscussionReplies: 16Last Post: 13-01-2015, 10:00 PM -
NEW MEMBER: tiny
By tiny in forum New Member IntroductionsReplies: 3Last Post: 02-05-2013, 10:15 PM -
WANTED: Need a tiny bit of work done on lathe
By Tenson in forum Items WantedReplies: 4Last Post: 28-02-2013, 12:22 AM -
Tiny tool feedrates
By Robin Hewitt in forum General DiscussionReplies: 7Last Post: 08-09-2010, 02:48 PM -
This tiny keyboard might come in handy :)
By Smiler in forum Gantry/Router Machines & BuildingReplies: 0Last Post: 28-12-2009, 06:30 PM
Bookmarks