Threaded View
-
01-05-2018 #1
Hi there
I am trying to use a probe sensor in order to set the tool height in my Tool bank, how this can be done?
Do I have to run this macro right after my m6 Macro?
Also how can I update my Tool Bank, after any reading of the tool height?
Finally any advise on the codes itself is greatly appreciated
Regards
Jhonansaro
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
tool probe problem
By johngoodrich in forum General ElectronicsReplies: 7Last Post: 18-04-2017, 08:08 PM -
Edge Probe + tool length probe on same input
By Noplace in forum General ElectronicsReplies: 1Last Post: 18-06-2016, 11:12 AM -
Help Please With Auto Tool Height Mach 3 Problem
By howser37 in forum Probing, Digitizing & ScaningReplies: 26Last Post: 12-06-2014, 07:55 PM -
Z AXIS, big tex blue screen and auto tool sensor Problems
By Tomnewry in forum Artsoft Mach (3 & 4)Replies: 11Last Post: 01-01-2014, 09:01 PM -
Tool Height Setting Probe - Mach3 - solution
By HiltonSteve in forum Tool & Tooling TechnologyReplies: 18Last Post: 12-11-2013, 06:23 PM
Bookmarks