Incorporating dxf file in design - help/advice needed

[Wal]

Hi Rob,

I downloaded your files, combined 'em and saved back out as a .dxf and a .pdf - sizes were a bit screwy - I take it you don't want a switch surround that's 1.5 metres across..? - Although it might make for a nice focal point for the room...

Anyway, here are the files:

https://www.dropbox.com/s/mxnewkwwev...FRAME.dxf?dl=0
https://www.dropbox.com/s/vrx4m0jlb1...FRAME.pdf?dl=0

Hope this helps!

Wal.

[cropwell]

Thanks Wal, The decorative scroll was too small, but at least it was addressable with my software. I corrected the size and have created the Gcode. The trial cut in a bit of scrap ply has finished and it looks GOOD !
I will set up a piece of perspex sheet and cut it out now.

[cropwell]

All cut out, now I need some bronze enamel to do the infills.