Threaded View
-
08-05-2018 #1
Hi all,
After Mr Leadhead of these forums very kindly popped by to check over my Chinese 4x4' router and discovered the Leadshine M542-05 Y axis driver was indeed shot, I bought a JMC 2DM542 and installed it, connecting the wires like-for-like.
Y axis now moves in the wrong direction.
Now, if i was using Mach 3 i seem to remember there was a toggle to mirror an axis BUT i'm still stuck on NC Studio until i can afford a new control board (thinking Planetary; have heard good things) but in the meantime: anyone know a quick fix?
NC Studio has 2 identical checkboxes labelled Mirror Axis, but neither do anything.
The 2DM542 manual has a couple of wiring diagrams, nothing i can make sense of.
The manual also has a chapter on parameter settings, but apparently i need an HISU adjuster to alter them. There's one called Initial Direction Selection which looks nice.
SO, any hints and tips before i start switching PUL+/-; DIR+/- wires around on the driver?
Many thanks,
Will in Portsmouth
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
Dumb Reverse
By Leadhead in forum General DiscussionReplies: 3Last Post: 03-10-2016, 12:41 PM -
Is this motor faulty?
By Chaz in forum General ElectronicsReplies: 12Last Post: 30-11-2015, 10:26 PM -
Reverse engineering
By mikewatch in forum Probing, Digitizing & ScaningReplies: 1Last Post: 13-04-2013, 10:20 PM -
3 axis driver...Fuses keep blowing
By dudz in forum Motor Drivers & ControllersReplies: 5Last Post: 28-01-2013, 08:05 PM -
Zapp Automation CNC Driver Kit 4 Axis
By whensparksfly in forum Motor Drivers & ControllersReplies: 7Last Post: 01-03-2012, 01:54 PM
Bookmarks