Threaded View
-
11-05-2018 #1
So I have this cone/horn I need to CAD and potentially get machined and I need advise on designing it so it is practical to machine (and wont cost the earth)...
I am looking at a cone around 75mm long, with a ID of 16mm and 30mm on either side with flat ends of around 3-5mm and 20mm respectively.
What sort of thickness should I look to achieve and is 75mm too long?
This is what I am after doing.
Thanks
Jack,Last edited by JOGARA; 11-05-2018 at 07:07 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: Well here goes... Aluminium frame router design
By CharlieRam in forum DIY Router Build LogsReplies: 186Last Post: 11-05-2020, 12:39 PM -
Design of small router (700x900) for aluminium
By Edward in forum Gantry/Router Machines & BuildingReplies: 7Last Post: 16-12-2017, 07:34 PM -
Initial design advise wanted
By driftspin in forum Gantry/Router Machines & BuildingReplies: 45Last Post: 24-10-2017, 06:55 PM -
BUILD LOG: Small rigid router - Design advise needed
By mitchejc in forum DIY Router Build LogsReplies: 120Last Post: 17-06-2015, 08:12 AM -
Newbie design need advise
By mogu in forum Gantry/Router Machines & BuildingReplies: 3Last Post: 15-07-2014, 04:52 PM
Bookmarks