Thread: Control box rebuild
Threaded View
-
13-05-2018 #1
Progress on my first rebuild of my control box.
Initial photo shows what I started with on my 6040.
This is my first time wiring up anything other than a plug and never used solder before either so was a nice experience.
The 2nd photo which looks very messy was my first attempt at wiring everything and discovered I had two wires touching that fried a stepper motor.
The 3rd photo is me finished for now I've rewired the sheilded wires properly with heat shrink and a better job at soldering.
Thank you to you guys aswell for your input and advice.
Next step will be to wire the vfd to get mach3 controlling it.Last edited by Palletlad; 13-05-2018 at 01:25 PM.
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
REBUILD: Hardinge HC rebuild
By northumbrian in forum Lathe Rebuild LogsReplies: 29Last Post: 21-02-2017, 12:07 PM -
Centec 2A rebuild
By Web Goblin in forum Gantry/Router Machines & BuildingReplies: 3Last Post: 02-04-2013, 08:41 PM -
REBUILD: Blomqvist lathe rebuild
By Web Goblin in forum Lathe Rebuild LogsReplies: 9Last Post: 21-09-2012, 06:52 PM -
Stepper Driver Rebuild
By fidia in forum Motor Drivers & ControllersReplies: 0Last Post: 25-05-2011, 02:44 PM -
NEW MEMBER: New member wants to rebuild.
By black5f in forum New Member IntroductionsReplies: 2Last Post: 21-06-2010, 11:38 PM
Bookmarks