Control box rebuild

[erasma]

Hi There,

Nice looking box and work - Some ideas

1.) Fans - Try not have the fans on the same surface as the air will just go in and out across that surface you would want the air to go across the box as much as possible so maybe one on the bottom front into the box and one on top of the box - sort of how they do it on PC cases. you can always get a multi meter with a heat sensor to check your internal temps of the components

2.) EMI and Ground Loop - it's always difficult to know if putting so many switch mode power supplies close together will cause EMI issues. when you connect your table make sure you don't create ground loops. my machine is all aluminum and I was happily making ground loops all over my table.

Hi all, I'm having another go at the control box to get rid of the gremlins.

My first attempt failed ended up killing my drivers and breakout board with a static discharge (so I've been told) so have brought a new container with a metal backing and have started from scratch a new design.

I have made a video in order for you to review and see with your experienced eyes anything that stands out as good/bad, criticism is all welcome.


https://www.youtube.com/watch?v=FL1fY_2_VPo