Verification please

[BernieNUFC]

I ordered it as a Bull Mill specific for the rail and i figuered an end mill might be too harsh....hmmm
Anyway, i lead in/out both vertical and Horizontal of 1mm on a helix ramp, and an angle of 2 degrees the ramp dia being 7.5mm.
I had to redo the whole drawing so am now only just back at the cam setup stage, i hope to create and test the new toolpath tonight with a doc of 6mm (sorry battwell i had already decide on 6 for some reason but at least i am close :-) ) and width cut of 2mm.
Cheers Malc