AXYZ new software ??

[routerdriver]

Why do you think the software is too old?I have had the experience of recommissioning an AXYZ 6010 with the horrible Toolpath software and as long as we kept to XP there was never a problem with the actual software.The problem was that the age of the software limited the system to the use of file names with no more than eight characters (obviously it pre-dated Windows 95!) but in practice the machine did what we needed.Rather than throwing money at an upgrade,why not just get on with cutting some parts to see how you get on?

I found that the machine manual was at the very least quirky and suspected that the native language at AXYZ was French and the translation was shall we say interesting... For example,using the tool length sensor to determine the tool length was described as "qualifying the tool".I was fortunate enough to have a CAM system to generate the toolpaths and didn't have to learn the ways of the software to work from a dxf file input.

I would strongly suggest that you get the machine ready to run and then move on to learning more about the joys of the commands called up by F4,F8,F9,F12,F25(if you have a tool length sensor),F35 and F36.

If you can generate a series of commands for the machine,it will be a good idea to try your toolpath in fresh air at first and you may be surprised at where the machine tries to cut the part.One other thing to avoid is deleting old cutting files from the controller while running a job.I have done this to free up some space and what should have been the same part cut again wasn't as the control had selected the cutting file at a similar position relative to the first file name in the controller memory.Unfortunately,the selected file was for a piece cut from thicker material and while I was close to the machine,the spoilboard received a fairly deep gouge before I hit the stop button.All in all it is a useful and versatile machine after you get used to it's peculiarities.