Threaded View
-
21-06-2018 #10
Two tubes could be almost but not quite as good if the end plates were of infinite stiffness, the guy who suggested that obviously isn't aware of the concept of Triangulation in structural design or the properties of different cross sections in torsional load.
I don't find that surprising any more though ;-)You think that's too expensive? You're not a Model Engineer are you? :D
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Shallow channel/Contour
By dfox1787 in forum Fusion 360Replies: 6Last Post: 08-05-2018, 11:49 AM -
Beam choice
By idegraaf in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 22-03-2018, 07:38 PM -
BUILD LOG: New build - Steel - 3 Axis initially then conversion to 4 axis.
By Slixxor in forum DIY Router Build LogsReplies: 44Last Post: 29-12-2016, 02:57 AM -
DeskProto 3D cam software, forum support added!
By Lee Roberts in forum DeskProtoReplies: 0Last Post: 27-01-2014, 03:21 PM -
He's added a fourth axis
By GeorgeD in forum Gantry/Router Machines & BuildingReplies: 39Last Post: 01-08-2010, 08:33 PM
Bookmarks