plasma design 8' x 4'

[adscnc]

Cutting metal now. Big learning curve here!
Have already sold some cut plates off the machine.

The x axis rails are ground angle iron, have a look at the mechmate for info on this. Don't dismiss the idea as mad and bound to be inaccurate! Have a look at what the lads build on the mechmate.com. The Y rails are no2 ground v rail from Eurobearings. The V rails from superior bearing in USA. The geared racks from WMH bearings Tamworth.

Al

christmas is past!!!:naughty:
how is your build going i am hoping to build same sized plasma/router but racks etc to expensive,thinking about belt drive(see my linear drive thread)
where did you buy racks etc and how much if its not to cheeky to ask???
Tom