Threaded View
-
04-06-2018 #1
Hello, I've been using a Stepcraft 420 for a couple of years making parts for a microlight aeroplane from sheet aluminium. I was going to build a bigger, stiffer machine after much reading on here, but ended up buying the router member "Bigstu" built. Its a dual x-drive, 4'x4' aluminium frame gantry router, now filling a large part of my workshop!
I've now done the bits to the machine that bigstu hadn't gotten round to, namely tidying up the electronics and painting the steel parts. The initial flush of new ownership! With a bit of the usual set-up faffing, having had to pull it to bits to fit in a Volvo, its now working and producing parts 10x faster than the little stepcraft managed. But the stepcraft was an excellent introduction to the field - other than the occasional clean its worked without any problems, bar the early death of the Proxxon tool!
I'm based in the Lake District if I can be of help to anyone, in advance of me asking the same!
Cheers,
Paul.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
WANTED: Wanted: Tormach PCNC 1100 - Based in North West, can collect from Mainland UK
By jcarter in forum Items WantedReplies: 0Last Post: 05-04-2018, 12:17 PM -
NEW MEMBER: New member from West Sussex
By Ross-MTV in forum New Member IntroductionsReplies: 1Last Post: 30-10-2016, 09:12 PM -
NEW MEMBER: New member in the north east
By 1972 in forum New Member IntroductionsReplies: 1Last Post: 22-05-2014, 06:50 PM -
NEW MEMBER: New Member from the West Midlands
By biketrialsdave in forum New Member IntroductionsReplies: 16Last Post: 02-01-2013, 08:00 PM -
NEW MEMBER: New Member - West Mids
By NickW909 in forum New Member IntroductionsReplies: 1Last Post: 16-10-2007, 01:43 PM
Bookmarks