Christ that is one helpful chap and the software does everything i think I will ever need in regards to engraving.

I had a proper play with the machine last night, actually managed to make the motors move a lot quickly by changing the speed parameters.

I have a lot of other parameters which im not sure whats the bst setting for such as acceleration, deceleration (both in the motion and motor section)

I have set the blend option to .01mm as it was "juddering" when doing curve's when I set it to 0 but was not doing 90 degree points when it was set to 1.5mm

Estlecam vids have helped me shed loads so far tbf, going to watch the vids again tonight, but just need these parameters and any other which may be relevant explaining in layman's terms.

Learning loads each day now