leadshine mx3660 4th axis query

[JAZZCNC]

Hi Jazz
Here is a link http://www.leadshine.com/UploadFile/...3660d_V1.2.pdf it's on page 15 bottom left.

Cheers

Andrew

Ahh I was looking at V1.1 that's why difference.

Ok well the just means that this output can only send out 20Khz regardless of the input. So Controller can provide 200Khz but only 20Khz will be sent thru this output.
Regards the controller it's always a good idea to set the frequency to just more than you need which for a stepper system 100Khz is more than enough. This lowers the work the controller as to do.

[the great waldo]

Ahh I was looking at V1.1 that's why difference.

Ok well the just means that this output can only send out 20Khz regardless of the input. So Controller can provide 200Khz but only 20Khz will be sent thru this output.
Regards the controller it's always a good idea to set the frequency to just more than you need which for a stepper system 100Khz is more than enough. This lowers the work the controller as to do.

Hi Jazz
Thank you for the clear answer, much obliged.

Cheers

Andrew