. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 15-08-2018 #25
    Clive S's Avatar
    Lives in Marple Stockport, United Kingdom.
    Clive S
    Last Activity: 12 Hours Ago Forum Superstar, has done so much to help others, they deserve a medal. Has a total post count of 3,342. Received thanks 618 times, giving thanks to others 82 times. Made a monetary donation to the upkeep of the community. Is a beta tester for Machinists Network features.
    In settings tab, I typed I want to move it 50, and it did move 150, and mach 3 set it to 160 steps. Now in mdi tab, I typed g1 x100 f300, it moved 100mm but very very slow.
    The driver setting is at 800.
    Ok so now you have it moving the correct amount on the X axis.. Now change the driver steps to 1600 and do the same test re calibration. Also tell us what you have set the settings for on the motor tuning page Mach3

    Just test with one axis first

    re the spike, it is the same as earth rod . Re the water it was just to wet the ground around the rod to lower the resistance of the earth.

    Don't worry about the questions, we have all been there at some point.

    edit https://www.youtube.com/watch?v=R3fu...M7iZbmHUxO7K-u
    Last edited by Clive S; 15-08-2018 at 02:57 PM.
    ..Clive
    The more you know, The better you know, How little you know
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need a bit of help with servo settings/setup
    By alboy in forum General Discussion
    Replies: 1
    Last Post: 07-06-2018, 11:04 AM
  2. PWM Settings
    By Gunar in forum General Electronics
    Replies: 20
    Last Post: 16-02-2017, 12:33 PM
  3. Mach 3 default settings,
    By chris w in forum Artsoft Mach (3 & 4)
    Replies: 4
    Last Post: 08-01-2016, 01:54 PM
  4. Home Switches & Slave Axis in Mach 3
    By Tenson in forum Artsoft Mach (3 & 4)
    Replies: 14
    Last Post: 03-03-2014, 11:43 PM
  5. Help with settings!
    By Tenson in forum General Discussion
    Replies: 26
    Last Post: 30-09-2012, 11:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules