Help please. Dip switches and mach 3 settings

[Clive S]

Clive - is it not possible to put some big caps on the output of the SMPS's. Don't they have quite a wide input voltage range anyway ?

I was going to suggest that but never done it with SMPS's But would be worth a go.

[Radu_Andrei]

Clive mentioned a toroidal power supply in order to fix the rubbishness of the pole supply. From what I read online, it.s a transformer, a bridge diode and a few caps, with a DC output.
Does this not mean that I.m actually replacing my switching power supplies that came with the cnc kit?

[cropwell]

Clive mentioned a toroidal power supply in order to fix the rubbishness of the pole supply. From what I read online, it.s a transformer, a bridge diode and a few caps, with a DC output.
Does this not mean that I.m actually replacing my switching power supplies that came with the cnc kit?

Andrei - don't go chucking money about until we can get a proper understanding of the problem.

[Radu_Andrei]

Hi Rob.
At this point I can only exclude one problem at a time, and each modification requires money in a form or another. Not my favorite approach, but that.s how it is.
I think I just ˇˇresolvedˇˇ the desktop pc, as I did try installing windows xp sp3 x86 on a separate partition, and it failed at first attempt, and then it seemed to go through, and now the pc would not load anymore. I can.t even get into Bios. It loads the first screen, and it stays like this forever. I can press Del for setup and it says it is entering setup but nothing happens, and with Tab the same thing, and f8 for Bbs popup which does nothing as well.


I installed really hard windows 7 as well a while ago. It just failed so many times, but I could repeat the process. Now I can.t. Only dvds seems to work, no usb or sd.

[john swift]

which is the boot drive ?


try booting the PC with no drives connected
and see if you can get into the bios

If you can
try connecting the DVD drive and see if it will boot from the windows installation disk

if that works
next try adding the IDE drive

and then the crucial solid state drive


if all 3 drives are connected to the IDE ribbon cables

you can only connect one master and one slave to each cable


it looks like all three drives are set to master !

if you have two master devices on one IDE ribbon cable
that could stop the motherboard from booting and take a very long time to respond to attempts to boot in to the bios

do you have 3 IDE ports ?

John

[Radu_Andrei]

Hi John,
I.ve changed in Bios the boot drive to be the dvd drive, right before installing.
I.ll try tomorrow what you.ve just said in removing all things and testing.
I don.t know what an IDE drive is or how many ports I have.
Here.s a photo with the motherboard.

[cropwell]

That Mobo has 4 SATA and 1 IDE port. The IDE port will support two devices and I would recommend you use Cable Select on the IDE drives look at this ---- https://support.hp.com/gb-en/document/bph03792 With Cable select the master is the first drive i.e. on the end cable connector and the slave is on the middle connector
SATA does not have that option and I see that the small drive cable tied to the box is SATA.

If you can set up XP on a separate drive, I would recommend it and don't mess about with dual booting. It looks as though you have a corrupt MBR (Master Boot Record).

The Mobo manual is here if you need it https://www.dropbox.com/s/vmr7ucg4kw..._1333.pdf?dl=0