Quote Originally Posted by Radu_Andrei View Post
Point 1: I.ll mention again the vfd problem, as I guess I have to figure this out to.
I wired up the vfd, I change Parameter 1 and 2 to value of ..2..(for communication port control), then wired the 4 control wires like posted before ..the gnd pin goes to ACM, the 0-10v to V1, 1st relay pin (5th in order) to DCM, and 2nd relay pin to FOR., and then in mach 3, in motor outputs, I enabled the spindle, step pin 1, dir pin 0, dir lowactive and step I tried in all ways, step port and dir port both to 1, then in output signals I enabled output 1, port 1, pin 17, active low not checked, then spindle setup, relay control with disable spindle relay not checked, motor control with ..use spindle motor output.. and ..pwm control.. both checked and pwm base freq to 100, then in spindle pulleys, nr1 max speed 24000.
And it does not work. It does nothing when i press spindle cw f5, although the relay clicks on, and the voltage at terminal 0-10v is 9.54v The vfd just shows 0000000 on the screen.
What have I done wrong?
I am assuming you have a Huanyang VFD as I cannot find reference to it in previous posts and the one on your wall looks like one.

PD001 and PD002 should both be set to 1 (External terminal = 0 - 10 v external)

Cheers,

Rob