Quote Originally Posted by JonnyFive View Post

1) What are the consequences if I’ve under rated the transformer? The motors will struggle in the situation that they’re all maxed out? How does this actually manifest itself? Motors stall? Feed slows down and start to get rubbing on the cutter?

2) You mentioned checking the motor temperature and adjusting the current - how do you adjust it? Is it a software setting?

3) If I want to add an extra motor sometime in the future (4th axis) I can just add another transformer and wire it in parallel to the first one to give more grunt?

4) The drive accepts AC, I don’t need any kind of smoothing or additional circuitry - just wire direct to the drives from the transformer?
1. With a significant overload, the transformer will overheat leading to breakdown of insulation and/or burnt out winding. However, with short-term overload (say, no more than a few seconds with 2x overload) you will not see any significant effect and the transformer isn't likely to suffer. Output voltage will drop slightly below the nominal value but not enough to worry the stepper drivers. The motors will not notice. And even that level of overload is unlikely. Go 625VA and be safe to add a fourth axis if you like.
2. After my last posting, I went back and looked at your picture of your drivers. I was surprised to see that there was no current control setting. Usually, some of the switches are used for setting maximum current. So maybe these drivers have some kind of software setting, or they are pre-configured for a particular current. Did they come with specific motors? If so, ignore what I said because the manufacturer has already dealt with this one!
3. As per 1 above, if you go for an over-rated transformer you could safely add a fourth axis - just wire it in parallel with the existing drivers. Fourth axis is usually rotary and unlikely to even take as much current as the XYZ motors. Or add another dedicated transformer? Do not wire a second transformer in parallel with the first! Their output voltages unlikely to match closely enough. You do not need any connections between the two transformers. However, I doubt that you would need that anyway.
4. Yes, just connect transformer secondaries directly to the AC in terminals on the driver. If at all possible, you are recommended to wire each driver directly to the transformer, probably via a terminal block of some kind which can take all the wires. Do not daisy-chain more than one driver together (i.e. wires go to first one then continue to the next). Whatever rectification and smoothing is needed by the driver is handled by its internal circuitry.