yaskawa SVDG-7RA

**alaamomen9** · 29-06-2018

I have cnc router have 3axis when I see control unit I see it have 5drivers instead of 3
3 of them have same thickness and 2 have another thickness
what is the role of small drivers !?

Sent from my ASUS_Z00A using Tapatalk

**Chaz** · 29-06-2018

Follow the motor cables to the motor, that will tell you.

5 drivers could be for dual motors for Y (or X)? Is there a 4th axis? Is the spindle controlled by a drive?

**alaamomen9** · 29-06-2018

Originally Posted by Chaz

Follow the motor cables to the motor, that will tell you.

5 drivers could be for dual motors for Y (or X)? Is there a 4th axis? Is the spindle controlled by a drive?

no spindle have dedicated VFD
so If I have dual Y
Can I connect on the same output from interface board!!?
RichAuto Dsp A15

Sent from my ASUS_Z00A using Tapatalk

**Chaz** · 29-06-2018

Originally Posted by alaamomen9

no spindle have dedicated VFD
so If I have dual Y
Can I connect on the same output from interface board!!?
RichAuto Dsp A15

Sent from my ASUS_Z00A using Tapatalk

I dont know, not done any slave connectivity before. Im sure JazzCNC or others will offer some guidance.

**Clive S** · 29-06-2018

so If I have dual Y
Can I connect on the same output from interface board!!?

What do you mean by "If I have dual Y " you either have or have not!!

You have not answered Chaz re "follow the motor wires from the drives"

Pic off the machine might help. more info required

**alaamomen9** · 30-06-2018

Originally Posted by Clive S

What do you mean by "If I have dual Y " you either have or have not!!

You have not answered Chaz re "follow the motor wires from the drives"

Pic off the machine might help. more info required

manufacturer has used dsp0501
when I see manual of dsp It was support step motor only !!
so what is corrert manfacturer or manual !!?

Sent from my ASUS_Z00A using Tapatalk