VFD HY only rotates at 12000rpm

[Neale]

I use a CSMIO/IP-M, and it takes a little bit of work to get it set up for analogue speed output. I would like to see a measurement of the CSMIO output voltage at the terminals just to check that it is actually configured correctly. The CSMIO plugin for Mach3 has some settings that are not obvious (although if you work through the manual very carefully they are documented) and you have to get this right. You should see 0-10V coming out of the CSMIO when it is configured correctly. Quick check with a voltmeter will confirm whether the CSMIO has been set up correctly.

[SaporeCNC]

Hello everyone
thanks to the help they gave me and was able to configure and apparently it works well,
when entering a G code, the VFD and the axis respond to the required speed,
in the week I will make some cuts and see how everything behaves ...

the changes you make to make it work were the following

pd011 configured at 150.00 is the minimum recommended in air-cooled axles and goes to 6000 rpm
pd070 set to 0 and thus works from 0-10v

thanks again for your time !!!!

regards