Quote Originally Posted by amxen View Post
im running the 5v needed to power it from the usb port as every one iv talked to say that's how they run it. so im not sure if the 2 end pins need connecting as its getting its 5v from the usb. from my understanding pin14 is en- and en+ goes to 5v on the end . only from what iv seen on other videos. so this is how I have it. some one has told me I don't need to wire in the en- for now just for testing but I have tried it both ways and it still the same. To be honest im going round and round in circles with this now
You should not need anything connected to the enable pin on the bob. Can you draw a simple sketch to show exactly how you have connected the drive to the bob.. I have used many of these bobs and they work fine