Threaded View
-
13-07-2018 #1
I have one of those super cheap NEJE DK-8-FKZ laser engravers.
For what it cost it does a reasonable if slow job. It successfully cuts brown paper to make stencils. it's limited 35x35mm workspace is not too much of an issue for me.
The software if comes with is basic but it does work.
However it works in a raster, so it scans across, one line at a time.
I assume this is because it's normally engraving bitmaps.
Is there a way to speed up cutting stencils by driving it in vectors? (without having to swap out the controller).
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Galss engraving/etching. Laser or engraver?
By Richard in forum General DiscussionReplies: 1Last Post: 18-07-2017, 12:40 PM -
eBay: Laser Cutter and Engraver
By andyp in forum Items On eBay UKReplies: 0Last Post: 01-03-2016, 10:49 PM -
Redsail laser engraver x axis problem
By sthdklen in forum Laser Machines & BuildingReplies: 4Last Post: 21-03-2015, 03:44 PM -
Cheapest yet CNC laser engraver ;-)
By Musht in forum General DiscussionReplies: 0Last Post: 13-02-2015, 06:36 PM -
eBay: Laser cutter/engraver
By Bartell in forum Items On eBay UKReplies: 2Last Post: 18-07-2014, 01:30 PM
Bookmarks