Thread: Mach3 and USB to cnc driver
Threaded View
-
24-07-2018 #1
Hi team.
I purchased a 2nd hand 300x400 cnc router that has the USB to parallel port conversion. See pic.
The previous owner was using madh3. Saw it running and have no issues parting with my Pennines..
So. I got it home, had a few health issues and then now finally after what seems like months I get it connected and downloaded the Mach3 software..
However connected the machine and my PC (windows 10/64) identifies it's there but I can't find the driver so I can connect.
It's identified in the device list as "CNC control via USB"
Would appreciate any help that you guys can direct me too..
Apologies if it's already been answered before but I have been searching the forum and can't find any info about it.
TIA.
Tried to upload a jpeg but says it's the wrong file extension. ,Last edited by Silver; 24-07-2018 at 09:55 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Looking for advice on converting driver on Boxford CNC Router to Mach3/4
By yankyg in forum Boxford RoutersReplies: 8Last Post: 20-02-2019, 11:40 AM -
XHC WHB03 mpg pendant Mach3 Driver
By Noplace in forum Artsoft Mach (3 & 4)Replies: 4Last Post: 07-12-2015, 06:43 PM -
FOR SALE: 3 Axis CNC USB Motion Card Mach3 200KHz Breakout Board For Stepper/Servo Driver
By dudz in forum Items For SaleReplies: 0Last Post: 03-01-2015, 03:40 PM -
Driver wiring to my computer for mach3 to control
By AdCNC in forum Motor Drivers & ControllersReplies: 13Last Post: 01-04-2010, 12:27 AM -
Mach3 / Laptop No line driver !
By bruce_miranda in forum Artsoft Mach (3 & 4)Replies: 1Last Post: 11-09-2008, 05:42 PM
Bookmarks