Thread: Mach3 and USB to cnc driver
Threaded View
-
25-07-2018 #10
Thankyou for that info Gerry.
I will look in to that but plodding out £100 and still having the same control card don't see much point investing money in getting this going when I will end up with the same board..
If I can't get a driver then I will upgrade the control system.
If UCCNC is worth a go then what board do I need to look at getting to enable me to run that software.. if it's not Grbl then what firmware is it?
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Looking for advice on converting driver on Boxford CNC Router to Mach3/4
By yankyg in forum Boxford RoutersReplies: 8Last Post: 20-02-2019, 11:40 AM -
XHC WHB03 mpg pendant Mach3 Driver
By Noplace in forum Artsoft Mach (3 & 4)Replies: 4Last Post: 07-12-2015, 06:43 PM -
FOR SALE: 3 Axis CNC USB Motion Card Mach3 200KHz Breakout Board For Stepper/Servo Driver
By dudz in forum Items For SaleReplies: 0Last Post: 03-01-2015, 03:40 PM -
Driver wiring to my computer for mach3 to control
By AdCNC in forum Motor Drivers & ControllersReplies: 13Last Post: 01-04-2010, 12:27 AM -
Mach3 / Laptop No line driver !
By bruce_miranda in forum Artsoft Mach (3 & 4)Replies: 1Last Post: 11-09-2008, 05:42 PM
Bookmarks