G-code failure help needed please

[Wal]

Hmm,

I'd hesitate to send you any code as what my software generates is very unlikely to work on your engraver (without me knowing exactly what post processor you use, where you're zeroing off etc. etc. - it's a bit of a minefield, best not go there!)

What I will say, though - is that the image you uploaded is far from ideal in terms of getting enough information from it in order to generate an engraving that's going to look any good...

This is likely to be a hiding to nothing, but I've poked it around a bit and improved the contrast for you so now it looks like this:



It's still not great, but the attached .pdf (look for it at the bottom of this post) now contains the vector (or line) information that your software should recognise and be able to use to tell the machine what it is that needs to be cut...

Wal.