Mach3 Lathe Threading Struggles

[m_c]

From the top of head in no particular order, the following support turn/single point threading-
Pokeys
PMDX
KFlop
CS-Labs (although I think you may need the higher end controller with an MPG module, and not the cheaper controller)
Centroid


IIRC Pokeys (and possibly PMDX) will work with a basic single/multislot sensor, whereas the rest require a proper quadrature output encoder.

[magicniner]

Does anyone do a good Stand Alone Controller for lathes?

[m_c]

Does anyone do a good Stand Alone Controller for lathes?

When I was looking at the Chinese standalone controllers, I'm sure some were available in turn versions.

[battwell]

https://www.aliexpress.com/item/Powe...caAi6yEALw_wcB