vfd query about the program settings for XSY-AT1 and air cooled spindle

[marbles]

Hi,

I have an XSY-AT1 inverter 3pH, i'm setting it up for the spindle below and just have a bit of a problem with the terminology in my manual, which differs from much of the documentation I see about the HuanYang, which I was using as a reference.

I'm just trying to get the basics set up, 400khz and min freq 120khz etc. What are the following setting I should input for the perameters below?

P00 Max voltage
P01 Reference voltage
P02 Intermediate voltage
P03 Intermediate frequency
P04 Min voltage
P05 Min Frequency
P06 Max operating
P07 Min operating


2.2kw air cooled spindle
current 220v
Current 6a
Frequency 400htz
speed 10-24000htz
2 pole

[Ger21]

I'll never understand why people keep buying these chinese VFD's that noone's ever heard of, and then ask how to set them up???
Did it come with a manual?

[magicniner]

I'll never understand why people keep buying these chinese VFD's that noone's ever heard of, and then ask how to set them up???
Did it come with a manual?

I suspect the reason is that, like many people, They're Cheap! :D

[Ger21]

But they're not any cheaper than a Huanyang, and in many cases, people pay more for them.

[magicniner]

I've stuck with the big 1st world names with brilliant documentation for 20 years, as I put a positive value on my time I figure I'm well ahead of the game ;-)

[marbles]

Apologies for the silence been in the Cairngorms!

I bought it because its dimensional height meant it would fit in my control box. It has a manual (of sorts) Here’s a scanned page with some of the key perameters to set.

If the Huanyang would fit in my control box I would have bought one.

[magicniner]

From the looks of that you need to set
Maximum Operating to 400 and
Minimum Operating to the correct percentage of 400 to give your spindle's rated minimum speed.
Reference Speed to 400 and
Intermediate Speed to halfway between 400 and minimum rated speed

[marbles]

thanks thats very useful information.

[shortcircuit48]

I have virtually the same setup as you but just cant get the spindle to run with any consistency. The spindle starts and slowly builds up speed but stutters and then trips out on Err 1 (Short circuit/Current overload/Power module protection). I have tried numerous combination of settings to no success. I assume you have your system running and would be grateful if you or others can point me in the right direction.

[marbles]

I have virtually the same setup as you but just cant get the spindle to run with any consistency. The spindle starts and slowly builds up speed but stutters and then trips out on Err 1 (Short circuit/Current overload/Power module protection). I have tried numerous combination of settings to no success. I assume you have your system running and would be grateful if you or others can point me in the right direction.

Sounds familiar . I'm not near the cnc till tomorrow but can paste the P1-P8 VFD settings, which might be of use.