Thread: Seig C3 CNC spindle problem
Threaded View
-
14-08-2018 #8
John - Thanks, the board is XMT 2360. The two blue wires are connected to the green chuck guard switch you have indicated. There are currently 3.6V across the terminals.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Huanyang VFD and spindle problem - VI/GND drawing voltage from my controller
By Mr*Beaver in forum Spindles & Drive MotorsReplies: 6Last Post: 20-12-2018, 03:40 PM -
Huanyang VFD and spindle problem
By BriceO in forum Spindles & Drive MotorsReplies: 20Last Post: 07-08-2018, 08:56 AM -
Problem with Spindle not spinning
By Noplace in forum Spindles & Drive MotorsReplies: 4Last Post: 22-01-2016, 02:40 PM -
seig x3 R8 V MT3
By dazza in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 18-02-2014, 01:14 PM -
CNC spindle control VFD problem
By djc in forum Motor Drivers & ControllersReplies: 1Last Post: 13-09-2009, 09:26 PM
Bookmarks