-
18-08-2018 #1
Good morning everyone!
I am in dire need for assistance..
My aim is to get a design cut out without it cutting into the design..
I have tried to adjust the start and finish depth, adjusted the origin on ncstudio but it's either too high or too low....
Please see the images....
Thanks in advance
Sent from my SM-G965F using Tapatalk
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How to use the tool height probe sensor?
By jhonansaro in forum Laser Machines & BuildingReplies: 4Last Post: 04-05-2018, 09:21 AM -
End Mill Height/Offset Setting
By cncJim in forum Tool & Tooling TechnologyReplies: 3Last Post: 05-07-2016, 01:08 PM -
Tool Height Setting Probe - Mach3 - solution
By HiltonSteve in forum Tool & Tooling TechnologyReplies: 18Last Post: 12-11-2013, 06:23 PM -
Problem with height setting in artcam express.
By don_jarr in forum ArtcamReplies: 4Last Post: 07-11-2011, 03:26 AM -
Setting Z height with an ER32 collet
By Robin Hewitt in forum Machine DiscussionReplies: 0Last Post: 27-03-2010, 09:16 PM
Bookmarks