DC stepper drivers in an AC system

[Benja]

Hey that doesnt look too bad, I'll have to figure a shopping list for RS then.
Going to Zapp this morning to pick up the 806's :)

[Clive S]

Hey that doesnt look too bad, I'll have to figure a shopping list for RS then.
Going to Zapp this morning to pick up the 806's :)

Here you go.:-
1 off https://www.rapidonline.com/vigortro...-x-25v-88-0012

1 off https://www.rapidonline.com/50a-brid...al-case-519318

3 off https://www.rapidonline.com/samwha-h...acitor-11-3121

3 off https://www.rapidonline.com/lcr-ep08...-clamp-11-3004

[Benja]

Here you go.:-
1 off https://www.rapidonline.com/vigortro...-x-25v-88-0012

1 off https://www.rapidonline.com/50a-brid...al-case-519318

3 off https://www.rapidonline.com/samwha-h...acitor-11-3121

3 off https://www.rapidonline.com/lcr-ep08...-clamp-11-3004

Bloody hell man, thank you very much. :) I think ive got a bit of AL that should do the job nicely too

[Benja]

806's now installed , using a leadshine switching psu at the min and will swap out for the linear once its built :) although the switching will work fine im sure sounds like the linear will be more efficient and possibly more stable in the long run. also fun to build! :) thanks Clive for your help.

Those drivers are night and day from the analogues I was using, motion is smoother and quiter even though ive gone from 1/10 to 1/5 Ms. Very happy but with a faint feeling I should have gone for the easy servo even though logic says this setup should be just as accurate.

Key thing for me I think is I know these are now running at full power. The proof will be in production.