Thread: UC300eth UB1 wiring help.
-
25-08-2018 #1
I purchase the UC300ETH-UB1 combo for my home build cnc, to drive 4x4NM stepper motors with
4x AM882H
1x72Volts PSU 7Amps
2x12 volt psu 330watt
HY VFD with 2.2kw water cooled spindle
NPN proximity switches.
The wiring is a headache for me, and this is what I have design until now, can anyone check and tell if I am at the correct path?
-
05-09-2018 #2
-
The Following User Says Thank You to pierantoine For This Useful Post:
-
05-09-2018 #3
I will check it,thanks for the reply!
-
05-09-2018 #4
1x72Volts PSU 7Amps
Not sure 7 amp is enough...
72v could be a little high 68v could be right to grt margin for back emf
.
don't connect limits on you bob but a relay cutting the enable and power of drivers
Also you should use the am882 alarm.
For vfd to bob use the rs485...
-
The Following User Says Thank You to pierantoine For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
New UC300ETH Breakout Board/Motherboard
By Ger21 in forum CNCdrive (UC100, UC300ETH)Replies: 10Last Post: 17-07-2019, 09:41 PM -
Probs installing UC300ETH on XP
By stirling in forum CNCdrive (UCCNC)Replies: 4Last Post: 21-07-2018, 10:04 AM -
FOR SALE: Uc300eth ub1
By Web Goblin in forum Items For SaleReplies: 6Last Post: 18-03-2018, 11:58 AM -
CNCdrive UC300ETH Mach3 plugin is now available
By A_Camera in forum CNCdrive (UCCNC)Replies: 94Last Post: 09-01-2017, 10:05 PM
Bookmarks