Thread: Stuck morse taper
Hybrid View
-
08-09-2018 #1
Is there a tool to help remove stuck morse tapers from the tail stock?
Sent from my SM-N910F using Tapatalk
-
08-09-2018 #2
Morse taper drift?, or if (like my ML7) you don't have a slot for the drift, I normally get a piece of bar through the rear bore of the tail stock butt up against the backside of the tool and tap it gently.
-
08-09-2018 #3
No slot for a drif. Here is my tail stock
Maybe some sort of wedge?
Sent from my SM-N910F using Tapatalk
-
08-09-2018 #4
I'm going to assume you've fitted some kind of short MT adapter that means when you wind the tailstock all the way in, the tailstock screw is not hitting the adapter and extracting it?
In which case, suitable wedge, but you'll probably have to make/bodge something suitable. Cheap hammer/fork type ball joint extractors would also work if you find one the right size.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
08-09-2018 #5
-
08-09-2018 #6
-
08-09-2018 #7
If you are lucky - a tap on the chuck towards the headstock, with a soft face hammer may dislodge it. Otherwise if you can wind the quill out (after taking out the pin) you may be able to get a drift into the quill to dislodge the bugger.
What lathe is it btw?
Got there - Hobbymat MD65Last edited by cropwell; 08-09-2018 at 11:25 PM.
-
09-09-2018 #8
I've took the tail stock part and noticed I couldn't get the screw all the way through the morse taper insert. I re tapped the part and I will see how that goes.
Sent from my SM-N910F using Tapatalk
-
12-09-2018 #9
We alway used to (and i still do on a drill press) take two hammers and simultaneously knock both sides of the socket at the same time, even very stuck tapers will come out then.
On a lathe there is more limited room mind you.
I used to have a Hobbymat MD65 like yours and when you wound the tailstock in it always pushed out the taper, rather a pain actually...Last edited by davo453; 12-09-2018 at 05:51 PM.
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Newbie: Boxford VMC 190, tool holder stuck and need a parts diagram / user manual
By amer_uk in forum Boxford Vertical MillsReplies: 0Last Post: 01-07-2018, 07:38 AM -
Laptop stuck in BOotmgr missing
By dazza in forum Laptops & TabletsReplies: 8Last Post: 28-02-2016, 07:08 PM -
feedrate stuck on low
By routercnc in forum Machine DiscussionReplies: 1Last Post: 24-04-2014, 10:24 PM -
Morse taper drills
By John S in forum Marketplace DiscussionReplies: 7Last Post: 08-05-2013, 07:00 PM -
250mW LASER stuck on
By korky in forum General ElectronicsReplies: 10Last Post: 12-07-2009, 10:47 PM
Bookmarks