Threaded View
-
08-09-2018 #2
Upload the "UCCNC.exe" to Virus Total. https://www.virustotal.com/
How many are detecting? Link the result.
The setup.exe is showing 3 now on VT (was previously one) after I just uploaded a fresh copy.
Probably just detecting with new virus signatures.
Typically you should not worry unless a good handful of the VirusTotal detectors come up with positives.
That being said, run a full system scan and keep an eye on the host computer over the next week or so.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
My UCCNC probing screen and macros
By A_Camera in forum CNCdrive (UCCNC)Replies: 6Last Post: 13-01-2019, 04:19 PM -
UCCNC MyProbe error
By chipxx in forum CNCdrive (UCCNC)Replies: 0Last Post: 22-08-2017, 02:36 PM -
UCCNC Software Info Request
By Roadrunner in forum CNCdrive (UCCNC)Replies: 1Last Post: 31-08-2016, 12:10 PM -
UCCNC and Rodocutter X4 Problems
By RusticRusty in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 06-06-2015, 09:01 PM -
At last, found the bug
By Robin Hewitt in forum Stepper & Servo MotorsReplies: 0Last Post: 20-12-2008, 07:14 PM
Bookmarks