2HSS86H Driver... AC or DC PSU?

[Clive S]

Ok, got it!
I´m gonna take your advice regarding the PSU and build a DC one with higher Voltage.
Thanks!

Ok don't worry about asking questions its cheaper than getting it wrong. Check out Joe's vid its a good guide.

This is a good place for a one stop shop https://www.rapidonline.com

[JW1977]

Ok, thanks!

[JW1977]

Hi!

I’m about to get the remaining parts that I need for the PSU and I would need some input.
Here is what I got so far.

Toroidal transformer, 2x36V, 800 VA. I intend to wire the secondary in parallel to get about 48V rectified.
A cap rated 80V, 27000 uF.

Looking at a rectifier rated at 600V 35A. I learned that the rectifier values should exceed the actual values.
My steppers are rated at 5 amps max and there’s 4 of them. Is it a problem choosing a rectifier that exceed the actual Volts to much?

Do I need a bleed resistor over the cap? If so, any recommendations of the proper value of the resistor?

Any recommendations regarding fuses? Type, value and so on?
I don’t know what they are called in English but I have seen like a flip fuse mounted on a din rail beside the PSU.

Volt readouts?

Would appreciate some input and input in general here, thanks!