Wrong cut

[driftspin]

Hmm probably you have checked this already.


Did you check for play on ballscrew angular bearings for the y-axis and x-axis.
The ballscrew locknut loosened on me earlier too... :-(

Does the problem move to the other axis when you turn the stock 90deg?

Grtz Bert



Verstuurd vanaf mijn SM-A320FL met Tapatalk

[cncnescu]

I already checked the backslash and is max 0.03mm on all axis. When I cut a normal wood plate(acacia for ex) along the fiber I will get the right dimension and this I will get regardless of the fiber orientation of the wood plate if x along the fiber or y along the fiber. Against the fiber is always the wrong dimension.
In MDF bought dimension are more or less equal but bought wrong.

[cropwell]

What are your steps per mm settings for x and y axis ?

[cncnescu]

I checked this at the beginning and it was fine...320 steps/ mm, 1600 micro steps on the stepper drive, 5mm / rev on the ballscrew.The same settings for all axis