Bridgeport Series 1 Interact. Refit/update . Opinions please.

[Chaz]

Thanks for the initial replies.

I have just ordered 3 AC sevo kits. (90ST-M04025 servo & drive kit)

220V A.C.
2500 rpm
4NM torque ( originals were 3.2)
Same shaft dia as originals
Motor body is a similar diameter and (shorter too), so they looked to be the ideal retro fit.

Its a bit late, but opinions invited on this purchase.

So next is controller.

My Interact has an auto oiler with what looks like a small stepper motor.
What is the best method of making this work ( any one done this, that can offer some detail)

Same as these?

http://vi.raptor.ebaydesc.com/ws/eBa...85755000&ver=0

Have you received them yet?

[swarf-boy]

Almost. Except I got the 90ST-M04025 model, which is 4NM and 2500 rpm.

[Chaz]

Almost. Except I got the 90ST-M04025 model, which is 4NM and 2500 rpm.

Ok, thanks. Received them yet? What do you think of them?

[swarf-boy]

I think they make an excellent garage ornament , as that is pretty much all they are right now.

Motors them selves appear quite well constructed. Seals on every joint etc. Bearings all feel nice. Keyed shaft is well machined. Drives appear well constructed too.

My only real gripe, is the 25 pin D connector that is on CN3.
It will have 3 or 4 different cable going to it eventually (including a shielded catb7 I think, for the encoder feedback).

Let you know more when my 24V PSU arrives.

[Chaz]

I think they make an excellent garage ornament , as that is pretty much all they are right now.

Motors them selves appear quite well constructed. Seals on every joint etc. Bearings all feel nice. Keyed shaft is well machined. Drives appear well constructed too.

My only real gripe, is the 25 pin D connector that is on CN3.
It will have 3 or 4 different cable going to it eventually (including a shielded catb7 I think, for the encoder feedback).

Let you know more when my 24V PSU arrives.

Great, thanks.

[battwell]

What control are you going with?

[Chaz]

What control are you going with?

Centroid Acorn.

[adunne123]

Great, thanks.

Hi Planning to up grade my Bridge port soon
Planning on using this and my old motors
Upgrading encoders
https://www.centroidcnc.com/centroid...ontroller.html
Any recommendations.
Thanks Anthony