I'm going to replace the original X, Y, & Z stepper motors on my BP Series 1 CNC with NEMA34 steppers. All electrics are being renewed. After a lot of homework, I *think* I've narrowed motor selection down to one of these two...

  1. NEMA34 1232 oz.in - 5.6amp, 5.5mH
  2. NEMA34 1100 oz.in - 4.0amp, 3.5mH

Using the formula '\sqrt{mH} * 32' gives me a recommended max voltage for the power supply of 75v for the 1232 oz.in motors, or 60v for the 1100 oz.in motors.

I'll make my own unregulated PSU so I've got some leeway in terms of optimising voltage and current to best suit the motors.
Drivers are DM860A (input voltage: 24-80VDC).

If I opt for the 1232 oz.in motors, a commonly available toroidal transformer is 100VA with 2 x 50v secondaries. Wired in parallel, that would give me ~70VDC and 20amps. Is that a suitable combination for the motors and DM860A drivers, or is a 70v power supply tak things too close to the 80v limit of the drivers?

Alternatively, I could build a smaller power supply for the 1100 oz.in motors (eg. 50-60v), keeping me well within the drivers' voltage range.

Of the two motor choices I've listed above, does one offer a performance advantage over the other? I'm leaning towards the 1232 oz.in motors but maybe I'm missing something?

Probably worth mentioning the mill's original stepper motors have a 2.5:1 pulley ratio on the X and Y axis, and 2:1 on Z. I was planning to reuse the pulleys - unless that's a bad idea?

Although I've done a lot of reading up on this stuff lately, I'm not confident I've got it all figured out correctly. I'd appreciate any advice or pointers as to whether I'm heading in the right direction re motor selection and power supply voltage. Cheers!