Threaded View
-
28-11-2018 #5
Last Activity: 10-02-2025
I misread the original post and as Neal said expressing it as 5000 of an inch is misleading. That interference is fine if it's measured correctly. It needs to be pressed on squarely using tallow. Pressing things square here is the key. Put a shoulder on the end of the shaft if possible that is a slide fit on the bearing then press. This will keep the bearing square. Also use tallow if you have any.
Last edited by spluppit; 28-11-2018 at 03:38 PM.
-
The Following User Says Thank You to spluppit For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Fitting HD 16 instead of MGD 16
By Noplace in forum General DiscussionReplies: 5Last Post: 28-04-2015, 09:08 AM -
taper roller bearings vs deep groove ball bearings
By dsc in forum Linear & Rotary MotionReplies: 8Last Post: 10-03-2014, 08:06 AM -
Simple Solution- Drive 1" Ball Screw Shaft with NEMA-23-Size Stepper Motor Shaft
By LoveLearn in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 08-02-2012, 01:52 AM -
WANTED: RM1605 Ballnut Tubes ( keep the bearings in place during fitting and transport)
By koogar in forum Items WantedReplies: 7Last Post: 28-09-2011, 12:04 AM -
Fitting new screws
By Robin Hewitt in forum General DiscussionReplies: 0Last Post: 15-02-2009, 09:34 PM
Bookmarks