Hi all,

Thanks for everyones previous replies, I never managed to get my router upgraded as per my previous posts as I managed to grab a hold of an old XP pc which got me up and running again with NCStudio.

Sadly this has now given up the ghost (I think the dampness in my garage is killing the pc's) and I'm now back to where I was before Christmas with a router that is now not working. I have been saving up my pennies for this day to come and have now decided its time to bite the bullet.

I have spotted the following on CNCDrive which is on special offer with a UCCNC licence included:

http://www.shop.cncdrive.com/index.php?productID=965

Can someone advise if this would be suitable for my machine?

I have a spare Windows 10 pc lying around which has not too bad a spec, other than a new PSU for the controller, what would I require to get my machine back up and running?

Has anyone any knowledge of this controller, is it fairly easy to setup and get running?

If anyone has any other suggestions I am open to ideas, obviously price dependant.

Thanks again